I am not so confident that you are right, but regardless of that, you responded to a thread which was very last posted to in 2005. I question if many of the individuals are still Lively.



I am basing that over a apparent reduction in powder residue remaining inside the barrels of my O/U right after employing Cheddite. Most of my loads are from the 9000-9500 psi range.

The sole assistance I give on which you will be entitled to count is the fact that which I am skilled to present and for which you have paid out me. Stick to all other suggestions at your very own hazard.

Add to quotation Only exhibit this person #9 · Apr 21, 2021 Nicely I shot the loads now. I bought fewer recoil I believe. The photographs felt smoother. I used to be capable of adhere to by much easier. Undecided if that’s since the velocity is just too large or too reduced.

Increase to quote Only demonstrate this user #2 · Aug 12, 2015 What's the profile of the load you now are using and therefore are contemplating substituting the Cheddite for your Earn primer? It will be valuable to determine what the pressure envelope of the present load is.

What I did do was point out the Cheddite primer is often a A lot nearer match into the Federal 209A primer which no person would advocate like a substitution for the Winchester 209 primer in ALL recipes.

This is an older thread, you may not receive a response, and will be reviving an aged thread. Please take into account developing a new thread.

Or Not one of the higher than? So there was a obvious transform in general performance. Also the sound was reduce than my previous loads which were Fed209A. Once i shot the Feds I modified my headset cause I thought they have here been away from location from your audio becoming too loud. However they ended up on just good.

I have loaded Countless Remington Gun Club, STS, and Nitro hulls and possess experienced no difficulty switching involving Gain 209's and Cheddites. This matter pops up occasionally And that i too was concerned when primer solutions became constrained.  

Ohio_Waterfowler said: Here i will discuss shots of Back and front of Cheditte primers that don't have CX2000 on them everywhere.

Only associates can shoot reloads as We've a vested interest inside the club not finding shut down. Should they consider Absolutely everyone's phrase for just what the velocities are they'll get shut down mainly because individuals You should not change what they have been carrying out to the 30 several years.

What do you think would occur for the strain for those who extra two.1 grains of Titewad powder to this load? Hint: Pressure will not go down after you incorporate powder.

From what several of us have found, that deal primer pierces easity. This causes speedy erosion of your firing pins which causes the trouble of piercing to get worse and that causes even more Firing pin injury.

"A effectively regulated Militia, being important to the security of a absolutely free Condition, the proper of your men and women to maintain and bear Arms, shall not be infringed"